|
It is sorry that the procedures cannot be opened because they are the controlled documents in my company. In fact, the reference is just used as the in-service check for the whole test setup. If there are something wrong in cabling, grouding, LISN and test receiver, then different test results will be obtained. Hence, you may feel free to select any reliable and stable source as your reference.
About the equipment calibration, the R&S test receiver already provides you the built-in self-alignment. Whenever you are performing the "CAL TOTAL", the equipment will automatically use its internal calibration signal source to have the self-alignment. For the details of this calibration feature, you may read your on-hand operating manual.
[ 此贴被kamleung在2011-04-06 17:56重新编辑 ]
本文由kamleung在供参考的旧版安规网发表，建议进入新版交流！
|
